Skip redundant pieces

How to Change Your Settings to Print a Single ARTS Form


An ARTS form will print for each plan code a student has listed. If only one ARTS form is needed for students with more than one degree code, follow these steps:
  1. At the ARTS Form Generation screen, uncheck the checkbox in the upper right hand corner labeled "Accept Processing Defaults."

    ARTS Form Generation screen

  2. When the Process Transcript File screen appears, uncheck the checkbox in the upper right hand corner labeled "Process Multiple Degree Codes (X)" and then click on OK at the bottom of the screen.

    Process Transcript File screen

  3. To save your settings, first click on the "Advanced.." button towards the bottom of the screen.

  4. Click on the "Set Map, Catalog, Degree & Config Defaults" button at the bottom of the screen.

  5. If you wish to save your settings so that they will be the same the next time you open ARTS, click "Yes". If you click "No", your settings will only be saved for this ARTS session and the old defaults will load the next time you open up ARTS.